On All Orders Over £120
£106.50 inc. VAT
Osmo Polyx Oil Raw 3044 offers the same high quality protection as the Original Osmo Polyx Oil without leaving a dampened effect on the timber. New untreated wood in its original form has a light ‘raw’ appearance. Osmo Polyx Oil Raw uses a small amount of white pigments to counteract the ‘damp’ look that will develop with clear oils. The end result is a smooth beautiful finish with nearly invisible protection.
|Brush, Roller, Pad
|Number of Coats:
|Drying Times @ 23°C
|Up to 5 years if can is kept dry and closed tightly
|Viscosity @ 20°C:
|>60s DIN EN ISO 2431/3 mm, thixotropic
Surfaces must be clean, dry and free of all dust and dirt contaminants. The maximum moisture content of the timber is 20%. To ensure the integrity of the finish and performance, Osmo recommend all traces of previous finishes are removed and the oil applied to clean, bare wood.
Existing oil finishes should be sanded back to clean bright wood prior to application of Osmo Polyx Oil Raw.
Pre-existing paints, varnishes, waxes and sealers must be removed completely, either by sanding or with a suitable paint stripper/remover.
Sand carefully before application, starting with coarse paper.
Final sanding for flooring: P100-150
Final sanding for furniture: P180-240
Ensure all sanding dust has been removed thoroughly from the surface. Degrease and remove surface contaminates using white spirit if required. Use a Wood Filler or Gap Sealer when repairing small holes/dents. It is not recommended to use the Osmo Wood Protector 4006 base coat when applying Osmo Polyx Oil Raw as this will darken the appearance of the wood.
Always conduct a test area before starting your project to check product suitability and final finish. Ensure you are following the manufacturer’s instructions on the tin at all times. It is recommended to allow the oil to warm to room temperature and stir thoroughly before application for optimum results. Osmo Polyx Oil Raw is ready to use, please do not thin.