BONDA WOOD STOP

0 Reviews

£8.41 inc. VAT

Not available for next day delivery. Please allow 2-3 days for delivery

Overview

Bonda Wood Stop is an air dried one-part filler for small holes, splits and damaged areas of wood.

Designed for use with both hard and softwood, Wood Stop is ideal for filling surface imperfections and damaged wood grain, so you can achieve a flawless finish.

The rapid drying formula is easy to sand and leaves the substrate with a smooth surface that is suitable for varnishing or painting.

FEATURES

Solvent free
Filler for small holes and splits
Rapid drying
Can be varnished and painted
Easy to sand
For interior and exterior use

Technical Info

Type	Air dried one-part wood filler
Intended Use	For small holes, splits and damaged areas on the surface of hard or soft woods. For interior and exterior use.
Coats	N/A
Curing Time	2 hours depending on the temperature and humidity. Do not use below 10°C or in high humidity.
Re-coating Time	Leave to dry for 2-3 hours before applying undercoat or varnish. Deep filled area may require longer.
Application Temperature	Ideally 15-25°C, but do not use below 10°C.
Clean-up	Clean all equipment immediately after use with warm water.
Hazards	Keep out of reach of children. Wash hands after use. A Safety Data Sheet is available upon request or from www.bondaglass.com

Usage

Bonda Wood Stop should be applied onto a clean and dry substrate.
Apply using a putty knife, forcing into the cracks and holes.
Leave slightly proud of the surface to allow for possible shrinkage and to enable sanding.
Allow to dry for 2 hours under good conditions.
Never exceed layers of 3 mm when applying or shorten the drying time.
If it is cold or damp it may require longer to dry.
If the hole to be filled is deep, it should be filled in layers of 3 mm allowing each to dry before further layers are applied

Documentation

Product Information

Review this product

Wish List

BON28102
BON28913
BON28302
BON28702
BON28002
BON28921
BON28402
BON28802
BON28602
BON28202